Reply to "throw out and Clutch Pedal linkage"

I got the MC stroke of 1.25" from a downloaded LARGE excel file of "all things Pantera".
Mine is frozen solid! Using the slightly less MC stroke would cut down my expected 7" pedal stroke.

the parts books and the TSB indicate differnt arm/shafts? I haven't written the equation to compensate for the large angle it actual goes through, I was just doing simple guestimating lever lenght on no angle. when I get a chance, I'll use the 2.6" arm in an offset slider-crank model and see what the results.

as for the throwout lever, I noticed I had my outer lever with the clutch slave, the inner arm is gone with the transaxle to Ron McC. looking at the scribbles on my pocket note pad, I think I measured the outer "B lever" at 2.5"
My desire with knowing this lever ratio is in setting the Throw out bearing pretravel. The instructions I have found (that make sense) is setting about 0.1" slave travel, but what would that be at the clutch fingers?

did you have to re drill and pin the clutch pedal to rod to set the clutch position when you installed the kit?