Skip to main content

Reply to "Throw out bearing touching clutch"

quote:
Originally posted by Peter Fenlon:
quote:
Originally posted by webbers:
I put a new throw out bearing in and a new clutch. The problem I now have and did not have before is, When I step on the gas, It will drive normal and get up to speed. But, Anytime I step on the gas a lot more the engine just spins. Should I have also changed the pressure plate? It ran before the change.

http://www.panteraplace.com/page124.htm


also
I had this info from McCloud.
The pressure plate needs 12.7mm of travel from the time the bearing touches the fingers to full release.
You should get about 1.524mm gap between the pressure plate and disc at the time of full release.

And finally (although this puzzles me) hydraulics should be fully bled and you have a gap between the bearing face and the fingers of 2.54 to 6.35 when the pedal is in the home position

Good luck with it, its a quirky area for certain. Pete
×
×
×
×