Reply to "TWO HOLLEY STRIP DOMINATOR MANIFOLDS ON EBAY"

...or you could just take a Torker manifold and put a 1 inch,(2 inchs if you really want to be bold)), 4 hole spacer on top as I did, since it's the same single planum(single plane) design as the strip dominator. It looks great having the holley sitting way up high behind the rear window! I think the strip dom. has smaller sized runners that up the velocity; as does RAISING the carburetor. But some have reported that raising the carb DECREASES the throttle response because it moves the carb,(which must meter off the vacuum SIGNAL), farther away from the vacuum SOURCE! I'll stay with the larger runners of the torker that match the ports of the four barrel heads. I have seen no signs of this "bottom end" loss of torque, some talk about! From 700-1000 idel rpm to whatever, this thing just moves forward at a high rate of speed!! Just my opinion, Marlin.

[This message has been edited by MARLIN JACK (edited 11-08-2002).]

[This message has been edited by MARLIN JACK (edited 11-08-2002).]