Do all panteras have the same geometry with respect to the control arm pivot points?
I have been reading about wheel offsets and geometry of the suspensions and have found that the requesters have not refered to the vehicle in question.
Just for reference Ford specifies the geometry in the following termonology:
(not a complete list)
Pt. 1 Front or rear upper control arm to frame, front bushing.
Pt. 2 front or rear upper control arm to frame, aft bushing.
Pt. 3 Front or rear lower control arm to frame,front bushing.
Pt. 4 Front or rear lower control arm to frame, aft bushing.
Pt. 5 Tie rod L & R.
Pt. 6 front or rear lower contol arm to knuckle
Pt. 7 front or rear upper control arm to knuckle
Pt. 56 Shock to LCA for SLA suspension
If any one has info on other points pleas repond. This is a good way to decribe where the location is, that you are refering too.
I engineer suspenson piviot points for Ford Motor Co.
I have made sealed ball joints for the shock mounts for my car. Is there a demand for these parts for the pantara?
Original Post