Reply to "Wilwood MC Question"

@trstno1 posted:

Thanks guys,

I ended up talking to Scott at SACC. Although he doesn't sell them anymore, he was super helpful & gave me all the Wilwood part #'s & tips on install. This is what I ended up ordering.

Wilwood Tandem Master Cylinder 1" bore

• 260-8555-BK

Wilwood proportional valve w/ right side bracket

• 260-15048

  Ipsco Master cylinder to brake booster adapter

  With this set-up I'll remove the original proportioning & shuttle valves & run all new SS lines.

  I will probably also replace or have booster rebuilt to look new as well. I'll also take the time to clean up the front trunk area. The old felt carpet is already removed, just need to decide on just painting it or installing new carpet as well.

After I fixed all the paint damage from 50 years of brake fluid, eating away on the paint, I glued 1/8 inch thick closed cell foam and then vinyl on top! This way, if you have a leak, you can wipe it off and neutralize with water!

and you can see if you have a leak because it doesn’t just soak into the carpet…