Hi Tim,
After talking with you last week you know I will be following this project very closely.
For those not following closely, this CNC programming Tim is doing for his new blocks is also applicable to used OEM iron blocks.
Tim first floated this idea in this earlier post, outlining the intended procedures and a cost of $999.
http://pantera.infopop.cc/eve/...171057856#8171057856
And folks thought the Cleveland was just going to fade away .........
Not.
Larry
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.