Used Crank, cam, pistons, con rods, oil pump, fuel pump

The issue is going to be, you can get a fresh cut crankshaft for $150 and rebuilt rods for $8 each. No exchange.

For that it doesn't pay to ship these parts. Particularly the crank.

Yeah, I hear that. What about pistons, look new and cam or oil pump?

All scrap. Aluminum was up to a dollar a pound. Usually settles down to $.23. Would you want a used camshaft? Same with the oil pump. Cast iron and steel sells by the ton.

Unfortunately my air filter washer ended up in #4 cylinder bore and as best as we can see with a scope is embedded in the piston edge so I'm probably going to need a single flat top piston.

$?

Bob

Bob, pm me a reasonable offer

Gotta get mine out and verify specs. first.

What are your piston specs?

Not sure, I know the cylinders were 30 over before I did the rebuild. They are pretty clean, almost odd looking with little to no carbon on them.

I assume I have original spec pistons if the mileage is accurate but who knows until I pull it out.

Thanks
Bob

If it's not to painful, what is a air filter washer?

quote:

Originally posted by Bob Hudson:
Unfortunately my air filter washer ended up in #4 cylinder bore and as best as we can see with a scope is embedded in the piston edge so I'm probably going to need a single flat top piston.

$?

Bob

quote:

If it's not to painful, what is a air filter washer?

Here you go.

Not painful at all.

Pantera Chris

I could have saved myself some embarrassment by just stating I was looking for a piston without the reason.

Per manufacturer instructions I had a washer above the positioning nut on my carb air filter stud because I was using a K&N Xtreme filter top. I had intended to acquire a flange nut eventually and install it upside down.

I assume it stuck to the bottom of the filter when removing and fell off in the carb in the process and apparently in haste I did not notice it missing when reinstalling the filter top.

Air volume at 5600 RPM it moved it to #4 cylinder and now it's a ball of steel in the piston top.

What can I say?

Bob

Ouch....Bob, stuff like that happens, the good news is that it usually doesn't kill us but makes us stronger or smarter.

Hearing your story, makes me sure that I only want the shipping cost for 1 or all of the pistons/rods if they will help your situation.

Guess you need to find out if they will work. I can send pics or whatever will help from my end.

1topcat

I'll let you know.

Thanks for your help.

Bob

1topcat,
Sell local , craigs list, 351C forum, mustang forum, ford trucks ,http://351c.net/board/, your area has plenty of folks in need of non import parts.
Mark