Skip to main content

Closed1 reply

Adjustable rockers vs shims

G Guest
Just got my heads back on and find that I need to adjust valves since the heads were resurfaced. They only took off .008" but it may have been done before. The process of shimming the rockers sounds like a long and tedious job. The local hot rod shop has an ajustable rocker kit for $175. That sounds like it may be a worthwhile investment. Any opinions?

------------------
Original Post
bosswrenchbosswrenchMember
Dunno what their 'kit' is, but it may be similar to Crane Cams' adjustable rocker assembly that allows Boss-type adjustable rockers or full-roller rockers to be added to non-Boss heads without machining your std heads or replacing pushrods. The Crane setup is routinely used on 351Cs with good success, as long as the installation is done to the letter of the instructions. Failure to use Lock-tite on the fasteners as directed or not torquing the assembly correctly will buy you a fair amount of trouble in a very few miles.
Views: 55
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×