Skip to main content

Replies sorted oldest to newest

Sorry so late to chime in - wanted to share a few photos of replaced parts from 8MA1010, which has the later type door trim.  Not sure at all about the earlier design, but my probably OEM whisker heights were 19mm (inner) and about 30mm (outer).  They both have bright stainless strips on top for decoration (see photos).  Photos show stock inner, replacement inner, and replacement outer whiskers.  The stock outers were totally deteriorated; I didn't save any of those crumbling bits for posterity.  I think the replacements came from Re-originals, listed as Alfa parts, possibly, but it was a number of years back now

The outer whiskers were secured with small flathead screws, while the inners were riveted to the large stamped steel trim panel found on the inner tops of 'late' doors.  If you have the early door design, I assume outer whiskers would be the same as these, but the inners could easily differ.  Either way it takes time to aligned everything properly!  Regards, Nate

Attachments

Images (3)
  • IMG_4430
  • IMG_4433
  • IMG_4434
Last edited by nate

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×