Skip to main content

Closed6 replies

ENGINE CRADLE PLANS??

lf-tp2511lf-tp2511Member
Does anyone have a set of plans for a SBF engine cradle? Not an engine stand, but a cradle with four rollers that attaches at the stock motor mount sites and two rear threaded holes. They run about $60 but I can build one out of scrap angle iron lying around the homestead.

Planning on pulling the Cleveland out of my old '65 Econoline before sending it off to the great garage-in-the-sky and want to have the engine storable/rollable.

thanks,

Larry
Original Post

Replies sorted oldest to newest

lf-tp2511lf-tp2511Member
Yup - that's the idea. I guess what I need is the width from left side to right side engine mounts......spacing of the two engine mount holes on each side.......and also, but not on your design, location of two rear uprights that can be bolted to a couple of bellhousing bosses.

I do not have a block on hand - want to fab this ahead of time.

Larry
lf-tp2511lf-tp2511Member
quote:
Why to the back of the bell housing? If you go this way you can roll be ZF right up to it.


Not bellhousing - bellhousing-to-block bolt bosses. The female threads in the back of the block. I want to support the block at the motor mount points and at the rear for sturdiness. Cradle is just to store a spare Cleveland block.

Larry
Views: 338
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×