Skip to main content

5 replies

Axle Shaft LH/RH (Which Side?)

jwelch68jwelch68Member

Does anyone know which side the left-hand threaded axle should go on? I assume it matters.

I'm starting to wonder if the previous owner may have put the axles on the wrong side.  Someone definitely went at the axle nuts with something other than the removal socket as they are buggered up pretty bad.

Thankfully I was able to clean up and remove the axle nuts with the use of Larry's socket.

I noticed the RF spindle uses a left-hand thread nut so it seems like the RR axle would use the left-hand axle nut as well.  However, on my car the LR assembly uses the left-hand threaded nut.  Seems like they may have the axles on the wrong side.

Any thoughts?

Thanks,

John

#2551

Original Post

Replies sorted oldest to newest

bosswrenchbosswrenchMember

Over the years I've found front left hand nuts on BOTH sides, on cars that had never seen service. So apparently sold that way from the factory. One CA Pantera had a pushbutton (removable) right spindle while the left  side was the later integral forging type.

When L models came out in late '72, left hand threaded spindles disappeared while the stub axles always had lefties- also occasionally interchanged side to side. So given the mileage these cars get nowadays, it seems not to matter much.

Add Reply

Views: 495
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×