Skip to main content

Closed1 reply

Edelbrock 351c Torker for high-port heads

panteradougpanteradougMember
This is an Edelbrock Torker that has been modified to run with Motorsport B351 heads. The bottom of the ports are filled with Devcon Plastic Aluminum Epoxy. As I recall about $50 worth, but that's water under the bridge.
If you have a set of these heads and need a manifold for them, here ya go...cheap...$100
Call me on my cell at 914-826-7683, or email me at hammer99@erols.com, or just reply to this add and I'll get email notification. Thanks Smiler I can email you pictures, the files are too big to post here.
Original Post
panteradougpanteradougMember
Just in case anyone cares, this manifold can be used on 4v iron heads. Since it started life as a normal Edelbrock Torker for iron heads it will still fit them. If it was used in that manor now, because it has been ported down, it will make throttle response sharper and will bring the power range down somewhat. I don't know exactly how much but I would suspect something in the range of 500 rpm's. A torker normally will turn on at about 4200rpm on 4v iron heads in my experience. I am guessing that this one would be noticable at around 3700 or so.
Views: 108
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×