Skip to main content

Hello all,
When moving the ignition switch in position 2 I always get a "clong" noise from the engine bay. I thought that it was coming from a relay, but according to the wiring diagram there is only the starter relay in that area and that one is active in position 3 only. Could this noise coming from the A/C compressor clutch? We have in South of France right now below freezing temperatures and that noise disappeared (is that normal and a protection mode?). I have no fluid in the A/C, however the fan of the A/C radiator is running all the time when ignition is put on. Is it possible that the A/C compressor of the A/C is still engaged even with no fluid inside?
Brgds
Hartwig
Original Post

Replies sorted oldest to newest

Strange things happen when the 43-year-old ignition switch contacts wear. Just be very sure that noise is NOT the starter solenoid trying to reactivate! By removing the rear upholstery panel, then the steel firewall access panel and trying your key, the noise location should be immediately obvious.

The Pantera was built as a basic supercar; there are no stock electrical protection circuits in the whole machine, but previous owners may have done about anything imaginable in the wiring.
If the compressor is truly dry- no lube mixed with the freon- its quite possible to seize a compressor just like an engine run with no oil. This would then either break the drive belt or pop the compressor clutch fuse. There are no oil level sensors or any other protections, and with rotary compressors (not stock) there is no oil sump: all lube is carried in the lines. The stock piston-type compressor does have an oil sump that could have been drained.

Just take the upholstering panel and access door off and look inside while doing the thing that makes the noise. The car can be driven with the panels off if you're careful with your right elbow. It may not be the A/C but you'll never know by guessing.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×