all points are well taken.
for an engine that has been sitting for 30 years, should I expect that most of the rotating assembly (crank/rods/pistons) will need to replaced anyway. and more than likely the block will need the bores cleaned. If so, wouldn't going with a stroker kit be about the same cost?
I don't know what heads, valves, pistons or cam I now have as the story was when i bought it that "Crane" had built the engine for a turbocharger.
Now that I think about it, I need to get the engine/transaxle out to a shop before the body goes. Any one know the lenght and width so I can pick up some lumber for a pallet/box before I unwrap?
I have updated my wish list based upon the input recieved AND...with my google researching, I have discovered the Gr3s!
So again I'll ask for comments on the punch list since I plan to talk with a builder in the next few days
So again I'll ask for comments on the punch list since I plan to talk with a builder in the next few days
Attachments
Files (1)
PM sent!
Ron
Ron
Add Reply
Sign In To Reply