All the vendors sell these quite reasonably, with hoses and clamps included. They are stainless steel which tends to reduce radiated heat into the cabin as well as not corrode. Any muffler shop could make a set. Both are two-piece for easy installation while original mild steel ones had one full length and one two-piece. The stock full length one required the engine and ZF to be removed to change it. Or carefully chop it in half.
marlinjackThe Machinist #5723 AMARGOSA MACHINE 'Running on Empty- Middle of Nowhere'
...I use to sell the Straight Sections. Just go to a Metal Supplier and Buy 1-3/8" Stainless Tubing. The Boss is correct, with the Engine in place, the Long sections must be in 2 Halves, to Install. And The Ends will Not have the 'Hose Beading'.
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .