Installing outer window frame rubber

LOL very funny. Rather than sliding it into the channel try pushing the rubber to one side then use a plastic tool to squeeze it into the opposite side. No K-Y jelly is required this way.

Thanks for the quick reply. Sliding in was discarded without serious consideration. Your suggestion is exactly what I've tried. And tried. and left to right and right to left and front side each way and back side each way. So far not even a hint that anything will work.

quote:

Originally posted by George '37 #2098:
I started the installation of new rubber on the top of the door and rear edge window frame. I've tried the four ways that I can think of to do this but am having no positive results. I've used detailing spray as a lubricant. I have noticed that the new rubber cross section view is somewhat different that the old rubber.

Any ideas or suggestions on how to get the job done? (I've thought of KY Jelly but at my age I'd be embarassed to go buy it)

If you put a thin diameter piece of string around the inside lip of the rubber gasket then put the window assembly up to the body, you can take one end of the string and pull it. That pulls the rubber lip of the window frame into the body section of the car. It seems a little strange to explain, but that is how I reinstalled mine many years ago.

quote:

If you put a thin diameter piece of string around the inside lip of the rubber gasket then put the window assembly up to the body, you can take one end of the string and pull it. That pulls the rubber lip of the window frame into the body section of the car. It seems a little strange to explain, but that is how I reinstalled mine many years ago.

I don't think this will work for what the OP is doing. It does work for the windshield, rear window and side windows however.

Since I'm still searching for a clew for the installation let me clarify what I'm trying to do: On the very top of the door is a metal channel which holds a rubber weather seal. By example let's say the channel is a size 9. The rubber I purchased (supposed to be the right one) is a size 12. The tool I have used to push against the rubber I suspect was too thick for the task. I'm searching for something thinner which won't cut me or the rubber and is very strong. Haven't found it yet but I'm not going to the task beat me.

i have the right strips if you need them. mikedmayberry@hotmail.com

Use a vinyl bondo paddle to push the seal lip into place.they are usually made with at least two thin edges . can be cut into usable lengths and can be shaped with sandpaper to fit contours and or eliminate a sharp corners. dish soap makes a good lube and rinses off. also; just sayin tupperware is about the same material.....lol ...stay out of your wife's kitchenware!