I purchased the BC2055 brake kit from Bob at Precision Proformance back in 2018 and never got around to installing it until now. I also understand that Bob has passed away and I haven't been able to contact anyone at Precision Proformance to ask if I'm missing a line or I just don't get it. I installed the front Stainless brake lines with no problem. However, now that I have gotten around to installing the rear stainless lines I'm either missing a line or just don't get it. I have the line installed to the brake master and down to under the car as there is only one way to go there. I believe I have the correct line from that one that goes to just before where the motor is. This leaves me with one longer line with a couple of bends in it and two more shorter lines shown below. Can anyone tell me what lines go where as it seems as though I'm missing the line that would go to the drivers side of the vehicle? I don't have anything that appears long enough to reach the drivers side fitting. However I'm also confused as to how the lines in the picture would even be connected to each other or to whatever. Thanks in advance for any help anyone can provide.
