sheet metal parts identification help

bspj800Member

Looking for some help identifying the parts shown in the attached picture. I procured a large lot of mostly Ford parts. I recently uncovered these, and they were marked as Pantera parts. I have no idea if this is accurate or not. They look and feel like heat riser parts. I looked at hundreds of pictures but did not find anything, and figured my best shot would be from folks on a Pantera specific forum. Thanks in advance, John

Attachments

Hide

Images (1)

3/12/176:05 AM

❤️ 0

Original Post

Replies sorted oldest to newest

kingMember

In my opinion none of these parts are for a pantera.

3/12/1710:44 AM

❤️ 0

simonMember

Pantera snow scooter?

3/12/1711:33 AM

❤️ 0

ufo-lowI really DO need a bigger hammer!

I believe the top right and left pieces are both covers / shields for the wind shield wiper motor; slightly different versions of the same thing.

Center tubular part may be a heat riser from the exhaust manifold to the warm air port under the air cleaner "snorkel". Just a guess, as I have never seen one installed.

Bottom piece; I have no idea, though it looks like an air duct of some sort.

3/13/175:41 PM

❤️ 0

ufo-lowI really DO need a bigger hammer!

On second thought .... I looked at the tape measure: the pieces I thought were windshield wiper motor shields are too small for that purpose.

3/13/177:36 PM

❤️ 0

pantteraMember

UFO-LOW, I'm pretty sure that you are right about those l and r covers.......

http://www.panterapartsusa.com...l.cgi?prod_id=17016A

Top center.......As in the photo below of my (way too stock) Dec.'72 build L, I believe that it's either part of/another version of the exhaust manifold to air cleaner hose ducting.......

At bottom center could be part of either #1 or #2 here.....

http://www.panterasbywilkinson.../catalog/ill14d.html