Spacer for the hydraulic assist

I don't have the pieces available to measure (or to verify) BUT here is my gathered notes IF part 48 is what you are looking for

Thanks JFB, It's #48 and I see the dimensions at the bottom. Thank you sir!

 

Simply mount the slave to the bellhousing with the other two bolts and you
will have your exact measurement.

JT

On Sat, Aug 1, 2020 at 3:15 PM The De Tomaso Forums <alerts@crowdstack.com>
wrote:

Very interested in the answer here. I was replacing my slave cylinder and realized there was no spacer. The prior owner had just used a standard bolt to attach the bell housing to the engine. I ordered a spacer from a vendor which measured 2 5/16” but there still appears to be a gap between the bracket and spacer of 1/2”. I am wondering if the spacer from the vendor is too short or some mod has been made to my car. Does anyone have easy access to measure their spacer? Thanks. Shashi

 

 

My spacer measured roughly 3 inches. 

According to JFB's drawing above, the spacer is 75mm, or 3" (matching Husker's note).

 

Thanks for confirming. I must have had a brain fart not seeing the measurement in the diagram. 

I was refreshing a windshield washer motor this evening and discovered a
broken magnet in the case. Does anyone have a non-working parts motor with
which they are willing to part. Actually, I only need the motor's case to
which the magnets are attached.

If so, let me know your price

Thanks
John T
Texas

Probably not the forum you want to post this in.