Very interested in the answer here. I was replacing my slave cylinder and realized there was no spacer. The prior owner had just used a standard bolt to attach the bell housing to the engine. I ordered a spacer from a vendor which measured 2 5/16” but there still appears to be a gap between the bracket and spacer of 1/2”. I am wondering if the spacer from the vendor is too short or some mod has been made to my car. Does anyone have easy access to measure their spacer? Thanks. Shashi
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .