Skip to main content

4 replies

Steel heater hose tubes in shift lever tunnel

O old7Member
What is the secret to removing these two steel heater water tubes? I can see that they are held by what appears to be a spring steel clip just forward of the shift lever location by using a flashlight. Toward the engine compartment, I can't see anything, although they are very rigid, indicating that they are attached also.
Original Post

Replies sorted oldest to newest

liv1sliv1sMember
Good info. It's funny that I was thinking about this update after seeing the replacement tubes in Vegas. The only problem I saw was the lower replacement tube was not bent like the original to exit the tunnel side by side with the upper tube. The other change I would make would be to have both tubes exit with a 90-degree bend so the hose would go in straight.
It will probably be easier to do when I have the engine out again.

Add Reply

Views: 230
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×