Skip to main content

Replies sorted oldest to newest

...I would try this...Door panel off, Clamped to a 'Straight' Bar, then Masterful, Gentle, Exacting use of a 'Heat Gun'. Guide it Back into Form. Keep the Gun constantly moving the Full Length, NOT Too Close. Warming only, Very careful Not to Melt!! When it 'Contracts' should shrink back into place. Leave Clamped until cooled. Clamping is Most Important!

Good-Luck with it!

MJ

Last edited by marlinjack

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×