Wilwood Vented Rotors For Sale

Here is a side view.

Do you have the part #'s for them ... they dont look directional..the rears.

Ron

My Mistake! You are correct. They are not directional, only vented.Thanks, Kevin

Do you have the part #'s ?

Ron

I could be interested, but need to know what hats to get and costings.

I am going to try to get the numbers for the hats for you. These were from the wilwood kit that Hall Pantera sold for years and now Precision ProFormance sells also. I believe the setup that Pantera performance sells is different, at least as far as the brackets and hats are concerned. I know that wilwood sells the hats for about $110 ea and Precision ProFormance sells a kit with all four hats with the front hubs for about $975 ( the hubs are the same price as wilwood around $110 but he only sells it as a set. I will also look for the number of the rotors.

I have a new set of Wilwood hats at home with the #'s stamped on them, I can post the part # later this evening.

I would like to buy them ... but need to know if they work with my set up. I bought all the parts and made the brackets. So the rotors have to be the same part #'s for me to purchase them.

Thanks Ron

Ron,
I'll See what I can find out.
Thanks,
Kevin

It may or may not help you but mine are #170-0635 and have following specs;

Rotor Bolt Center 8 x 7.62", Wheel Lug Pattern 5 x 4.50", Hat Offset 1.38", Stud hole Dia. 0.67" Center Hole ID 3.23" Face Thickness 0.25" Clearance ID 6.27", Mount Hole 0.323"

There aren't that many choices on the 8 x 7.62" RBC and 5 x 4.5" wheel lug combination, so you should be able to verify fairly rapidly ( , pun intended). At worst I'm guessing you can get the vernier gauge out and measure.

Ron ,
Here are the measurements of the rotors:
fronts- 12 3/16" X 1 1/4"
rears- 11 13/16 X 3/4"
I had always thought that most of the standard Wilwood Pantera rotors were the same size unless you went oversize (which is what I had done in order to fill up the larger wheels) and that the thing that varied was the hat or type of hat.
I will see if I can round up the rotor numbers between today and Monday.
Thanks,
Kevin

Heres what I used

WIL 160-3872 Front right rotor 12.19 dia directional
WIL 160-3873 Front left Rotor 12.19 dia directional
WIL 160-5844 Rear rotors
WIL 170-0635 HATS

and made the brackets out of steel not aluminum.

Ron

and rears.

Ron,

Nice work on the adaptors.... Do you have any front view pictures? Thanks.....

Thanks .... no I took them all apart ..there is 2 - .060 shims needed to center the caliper on the rotor. I didnt want it exact so in the future I have some play.