Horace please see this link. They have a variety of Dash Vents.
http://www.carbuildersolutions...wMode=grid&orderBy=0
Those are nice. Thanks for the link.
Goodroc
Great find!!
Thanks, that link just what I needed
Jay
Great find!!
Thanks, that link just what I needed
Jay
Thanks for the link Goodroc
But if you look at my earlier post I mentioned this same company Car Builder Solutions. As I said, they do a lot of similar vents and if I can't find originals I may have to use something from them.
However while they all look interesting look a bit closer at the info on their vents and there is only really one that will fit into the 75mm hole in the top of the Pantera dash and thats the 100mm Rocking Vane they list.
If you read the info this takes a 63mm ducting tube while the Pantera heater and defrost outlets are 45mm so there will need to be an adaptor of some sort fitted to accommodate these vents to the Pantera heater.
It would save a lot of hassle if I could get originals or copies of the originals from one of the vendors, hence this thread, but if not I may have to look at the above.
Cheers
But if you look at my earlier post I mentioned this same company Car Builder Solutions. As I said, they do a lot of similar vents and if I can't find originals I may have to use something from them.
However while they all look interesting look a bit closer at the info on their vents and there is only really one that will fit into the 75mm hole in the top of the Pantera dash and thats the 100mm Rocking Vane they list.
If you read the info this takes a 63mm ducting tube while the Pantera heater and defrost outlets are 45mm so there will need to be an adaptor of some sort fitted to accommodate these vents to the Pantera heater.
It would save a lot of hassle if I could get originals or copies of the originals from one of the vendors, hence this thread, but if not I may have to look at the above.
Cheers
When I talked to Wilkinson last week he said he was getting dash vents made.
Have you considered having vents 3D printed?
Have you considered having vents 3D printed?
Hope you're right about Wilkinson having some made but when ? These things seem to take months if not years.
Good idea about the 3D printing option but I don't know anybody with a printer that could do them. Anybody got access to a 3D printer ??
Might possibly have an option to borrow some from a Pantera undergoing long term restoration but I will need a permanent solution eventually.
Cheers
Good idea about the 3D printing option but I don't know anybody with a printer that could do them. Anybody got access to a 3D printer ??
Might possibly have an option to borrow some from a Pantera undergoing long term restoration but I will need a permanent solution eventually.
Cheers
I should have a set from my GTS dash that you can borrow for your LMC trip if you run out of all other options.
Very kind of you Kristian and I may very well take you up on it if the UK option to borrow some should fall through.
Will send you an e mail if I need them. Hope to see you at CLM, French fuel strikes permitting !!!
Cheers
Will send you an e mail if I need them. Hope to see you at CLM, French fuel strikes permitting !!!
Cheers
Here's the right hand side cup.
http://www.ebay.com/itm/DETOMA...AOSwR5dXRgB6&vxp=mtr
The left hand side cup is 45 degrees.
http://www.ebay.com/itm/DETOMA...AOSwR5dXRgB6&vxp=mtr
The left hand side cup is 45 degrees.