Ok so its been a while .. but Ive made progress and finally found some time to make some huge leaps on my project with the help of Anthony and Colm and the Boys at Ramapo Collision.
Yes the brakes we measured up and spec some WILLWOOD #'s and made some brackets and shims ... not extreme but sufficent enough to stop the car .. 12" / 4 piston.
Who's flairs? Interesting question ... let me just say I used two sets for the rear because they fit very poorly and the fronts I cut them significantly to make them fit ... The wheels supposedly were a std offset ? Anyway this is why the project had stalled for a while ... Nothing I bought fit properly ... Including the carbon fiber hood and deck lid.
marlinjackThe Machinist #5723 AMARGOSA MACHINE 'Running on Empty- Middle of Nowhere'
...Beautiful Work!!!
And I sure don't wish to 'Rain on Your Parade'! But, just a 'Heads-Up', That Distributor Is Too Large a Diameter for the Pantera! It will NOT Clear the Rear Window Glass. And be Most Sure to Take it Out before trying to Install the Engine, or You are Guaranteed to Hit and Break the Glass!
Just Friendly Advise. The Bodywork looks Spectacular!
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .