Skip to main content

Closed1 reply

tail lights

G Guest
I removed the tail light housing and and when I reinstalled it, the passenger side tail light stopped working. I removed the plastic housing, made sure the wires were attached to the ground but it still doesn't work. The wiring diagram shows a ground to the a/c condenser which looks OK. Is there anything I should know about the tail light housing that could be causing this?
Original Post
marlinjackmarlinjackThe Machinist #5723 AMARGOSA MACHINE 'Running on Empty- Middle of Nowhere'
MAKE ABSULUTELY SURE THAT THE LIGHT BULB ITSELF IS PROPERLY SEATED IN IT'S SOCKET! AFTER YOU'VE CLEANED ALL CORROSION OUT! I REPLACED A TAIL LIGHT BULB A FEW WEEKS BACK AND IT DID NOT WANT TO SEAT, I HAD TO WORK AT IT. YOU SAY YOU HAVE THE GROUND WIRES(MORE THAN ONE) HOOKED UP! THE ONLY THING ELSE I CAN THINK OF IS TO CHECK YOUR FUSES, YOU MIGHT HAVE BLOWN ONE IF THE BATTERY WAS STILL CONNECTED, AND YOU HAD THE DISCONNECTED WIRE CONNECTIONS HANGING. GOOD-LUCK, MARLIN.

[This message has been edited by MARLIN JACK (edited 06-14-2002).]
Views: 73
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×