Skip to main content

Replies sorted oldest to newest

I guess this falls under the catagory of "I'd rather be lucky than good" Trying to track down a electrical problem with the turn signals not working. Pushed in the hazard button, nothing. happened to bump into the wiring harness under the dash near the speedo while the hazard button was depressed and everything started working again. Just a loose connection. I'll take good luck any day of the week.
Feeling a bit of an idiot at the moment. Could not get a good brake peddle. Bought new master cyl, rebuilt the calipers with new seals and pistons and went for the steel braided brake hoses. Changed from dot 3 to 5, flushed and bled the system still could not get good brakes. After hours of trying to figure it out, I called for help only to find I had the front calipers on the wrong side which meant the bleeder screw was at the low point on the caliper and therefor could not get the air out of the system. Stupid mistake cost plenty of $$$ and hours of head ace . Now to figure out why my clutch peddle goes to the floor. Also just flushed and changed to Dot 5.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×